DEBUG:

  • MONITORING tips
    • Use the MIDI MONITOR of the Preset Editor and get familiar with the MIDI Filters.
    • There should be NO MIDI activity when nothing is touched or moved.
    • Keep the Distance sensor disabled (SW2) , unless you are testing it.
    • Check if buttons produce a clean on-off midi signal.
    • Do the same with Touch sensors and test upper/lower threshold values (editor -Touch mode)
    • Check if all pots produce a clean continuous flow of values.
    • Go on testing the Spinners and the in/out connections…

  • CONTROLBOARDS testing
    • Download the testing sketches.
    • do the LEDs test first.
    • Buttons/pots test

 


  • DEBUG tips
    • Clamp all Analog inputs of the Arduino board to GND, except the one you’re testing, and verify the solderings.
    • Editor: verify Preset settings for modifiers (problems may occur when buttons are set in POT MODE).
    • Editor: verify General settings for the circuit. The General setup is only accessible in EDIT mode.